-
Create a folder for each date of data on the external hard drive. Use a USB SD Card holder or SD Card holder to access the files on the SD Card. Select the files for one date and copy and paste into the folder you created with the same date. ...
-
-
All information and screenshots in this article have been sourced and reproduced from the metrocount.com website. Please note the screenshots used in the article are generic only, and are not specific to the Papua New Guinea road network. The ...
-
AWM Table : Bridges, Causeway, Major Culvert, Tunnel Attribute: Traffic Direction Purpose: To support consistent recording and management of road data, inspections, and maintenance by clearly defining increasing, dec...
-
AWM Table : Bridges Attribute: Analysis Method Purpose: To record the level of assessment applied to the road or structure, helping users understand the reliability and detail of the information used for planning, des...
-
This article demonstrates how to adjust the dimensions for a record. This may be needed when the actual length drawn is different from the calculated length (end location - start location) for the record. This is expected for records that either a...
-
To apply a filter to an asset table based on information in the carriageway table (such as province or sealed/unsealed network) the following steps should be followed (note that this article outlines how to apply a filter for province – if you wan...
-
It should be noted that AWM was previously referred to as RAMM. Thinkproject have created an in-depth (40+ page) step-by-step guide on how to use AWM filters. This guide can be downloaded here Filtering in RAMM.pdf . The guide covers the con...
-
Last Updated: 07/04/2026
in Asset Data RMS Data Standard
-
Purpose From February 2025, monthly project monitoring will be carried out in the AWM system. I t is important that the relevant provincial staff understand their roles and responsibilities, and have the knowledge necessary to...